Author Topic: Anybody ever experiment with drilling a hole or holes in a Norge windshield?  (Read 3270 times)

Offline Adk.IBO

  • Gaggle Hero
  • *****
  • Posts: 690
  • Location: Adirondack Mountains
Looking to get rid of or reduce buffeting. Thinking Cal-Sci effect or Gold Wing vent. Now that I think about it someone had snap vents available, I'll have to do some searching...
'09 Norge new in '11, sold in '17, 37000 very good miles, thanks to this forum. '17 Roadster new in '17
Luke 23:34

Offline rocker59

  • Global Moderator
  • Gaggle Hero
  • *
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 24322
  • "diplomatico di moto"
  • Location: Aux Arcs
Michael T.
Aux Arcs de Akansea
2017 Triumph T100 Bonneville
"Do what you can, with what you have, where you are." - Theodore Roosevelt

Offline Adk.IBO

  • Gaggle Hero
  • *****
  • Posts: 690
  • Location: Adirondack Mountains
Thanks Rocker!
'09 Norge new in '11, sold in '17, 37000 very good miles, thanks to this forum. '17 Roadster new in '17
Luke 23:34

canuguzzi

  • Guest
What else works? Those cable hole covers for desks. They make them in all kinds of colors including metallic. They don't open like a flip type ala Vetter but they rotate so you can adjust the air flow through them.

http://www.cableorganizer.com/round-grommets/


The Norge shield already allows quite a bit of air to flow underneath it though.
« Last Edit: April 30, 2015, 12:53:33 PM by Norge Pilot »


NEW WILDGUZZI PRODUCT - Moto Guzzi Door Mat
Receive donation credit with door mat purchase!
Advertise Here
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here