Author Topic: CalVin ECU re-mapping progress  (Read 1893 times)

Offline CalVin2007

  • fickle old fool
  • Gaggle Hero
  • *****
  • Posts: 762
  • Location: Central Kansas,USA
CalVin ECU re-mapping progress
« on: January 31, 2016, 08:41:44 PM »
 I've mentioned in a couple other threads that I've been messing with Guzzidiag and TunerPro in hopes of making my '07 CalVin run more to my liking. Well, I have changed things around quite a bit and made some good headway. First off...I replaced the stock 15RC ECU with a 15M from a 2002 Lemans. No real reason to do this,since my o2 sensor circuit had been turned off anyway but I had the ECU so I wanted to see what I could do. I completely erased the ignition table and rewrote it using a stepped scale starting at 10 degrees at idle and increasing to 32 degrees by 4000 rpm and staying there the rest of the way up to rev limit. I used the stock incremental RPM points for each step of the timing increase. It closely mimics an old points distributor with flyweights- increases with RPM only-no fancy stuff.
    Then I installed a fuel table for a V11 Ti exhaust setup and modified it with a bit less fuel in a couple spots and a fair amount more in several others...mostly in the 2500-4000 rpm and 60%+ throttle opening areas. Several test rides later and a few tweaks to fueling it felt pretty good...but the weather was lousy and I only got a couple good rides in.
   This weekend was nice! I rode a hundred miles after work Friday and another 70 today, and the CalVin is much improved. The dead-simple timing curve and the tweaked fuel map are MUCH better than the CalVin map,and also much better than a previous mail order remap I had done. This thing pulls HARD in the mid range at 1/4-1/2 throttle,just where most of my riding is done. Slow to first gear to make a sharp turn and crack the throttle slightly now and it is crisp and sweet as I grab gears and accelerate back to speed. It lunges eagerly ahead on gear changes now where in the past it grudgingly responded. Don't get me wrong-it was never "slow"but now it is impressive. The best part? Mileage improved with less timing and more fuel. (and in cold weather!) I gained 4 mpg...from 43 to 47 mpg. That's checking two tanks and riding it with enthusiasm so I am quite pleased.
   I plan to keep messing with it and will report more as things progress. I will also forward the map to those who have helped me out with this project. AND: Special thanks to Pauldaytona,Beetle,Beard,Meinholf and everyone else who have contributed their time,money and expertise to make it possible for us to do this stuff.  :thumb: :boozing: :boozing:

    Terry
 
'07 CalVin
 '79 TT500
 '78 SR500
 '80 SR500

Online Tom H

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 3798
  • Location: So. Cal.
Re: CalVin ECU re-mapping progress
« Reply #1 on: January 31, 2016, 09:00:02 PM »
Very nice!!!

With all the help I've had, my EVT runs pretty good. Might like to change the stock map, but still working with the bike.

Good luck!!
Tom
2004 Cali EV Touring
1972 Eldo
1970 Ambo V1000
1973 R75/5 SWB with Toaster
1973 R75/5 LWB
2007 HD Street Bob
1953 Triumph 6T (one day it will be on the road!)

Offline CalVin2007

  • fickle old fool
  • Gaggle Hero
  • *****
  • Posts: 762
  • Location: Central Kansas,USA
Re: CalVin ECU re-mapping progress
« Reply #2 on: January 31, 2016, 09:14:13 PM »
 And good luck to you as well,Tom...thanks again for your assistance!

  Terry
'07 CalVin
 '79 TT500
 '78 SR500
 '80 SR500

Offline Sheepdog

  • Gaggle Hero
  • *****
  • Posts: 5575
  • 2007 Moto Guzzi California Vintage
  • Location: Waldheim, Louisiana. USA
Re: CalVin ECU re-mapping progress
« Reply #3 on: February 01, 2016, 04:32:09 AM »
Sounds like a touchdown! Well done.
"Change is inevitable. Growth is optional." John C. Maxwell

Offline lazlokovacs

  • Gaggle Hero
  • *****
  • Posts: 1148
Re: CalVin ECU re-mapping progress
« Reply #4 on: February 01, 2016, 04:39:40 AM »
great stuff!  :thumb:

pm me the map and I'll do some independent testing for you...?


Offline CalVin2007

  • fickle old fool
  • Gaggle Hero
  • *****
  • Posts: 762
  • Location: Central Kansas,USA
Re: CalVin ECU re-mapping progress
« Reply #5 on: February 01, 2016, 06:51:59 AM »
 You bet. I'll send it tonight...and thanks for your help as well!
'07 CalVin
 '79 TT500
 '78 SR500
 '80 SR500


NEW WILDGUZZI PRODUCT - Moto Guzzi Door Mat
Receive donation credit with door mat purchase!
Advertise Here
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here