Shock Eye Bushing

[sithot]

Seeking a press in bushing to replace those in the bottom eyes of my V7 Sport shocks.

I did this a few years ago on another one but for the life of me cannot recall where I got them and Rick (MG) and I did the Tango yesterday trying to figure it out.
Don't think an Ikon is going to work but if it would I'm all ears.

Thanks.

Tom

[Sasquatch Jim]

  I would just go to my lathe and make one.
 Or, just get a piece of round stock of the right size or a tiny bit bigger, drill a hole of the right size and chuck it into a drill press and work a file against it until it fits.

[neverquit]

They are easy to make but if you don't have the means to do that you can buy all sorts of small metal bushings at McMaster-Carr.  Steel, bronze etc.  You might even find a piece of stainless hydraulic tubing or some other type of tubing at an auto parts store or hardware store that can be cut to length and used as a shock bushing.

[Antietam Classic Cycle]

The 76 series shock used on the V7 Sport has a rubber encased metal bushing like this:


IIRC, when I rebuilt a set of original V7 Sport shocks, the bushings I used were for Koni/Ikon 7610 series shocks. MG Cycle has two different sizes, I don't remember what the size was I used. I still have one bushing left from the ones I bought and can measure it in the morning if that will help.

http://www.mgcycle.com/index.php?main_page=product_info&cPath=197_200&products_id=4520
http://www.mgcycle.com/index.php?main_page=product_info&cPath=197_200&products_id=4521

[sithot]

Thanks gentleman! 

Charlie, I did have Gordon send me a pair of those.  Nicely done.

I'm thinking of doing my own but for now found a usable pair.  One of my partners in crime is a machinist and likes one-off stuff so he'll get the nod when it's time.

Best to all.

Tom