« previous next »
Pages: [1]   Go Down

Author Topic: CX100 Restoration  (Read 10860 times)

Offline Dluke

  • New Egg
  • *
  • *
  • Posts: 4
  • Location: Bend, Oregon USA
CX100 Restoration
« on: August 15, 2021, 05:56:54 PM »
I am restoring a 1981 Lemans CX100. I am trying to source a new headlight which is a sealed beam unit. I have all of the mounting hardware (shown in photo) but the light itself was broken. I have been told that I can possibly try an automotive unit. If anyone has any guidance it would be very helpful. I have checked with all of the traditional sources, (MG, Harpers, Cycle Garden, Mark Etheridge, Greg Bender)

Logged

Offline Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 15180
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: CX100 Restoration
« Reply #1 on: August 16, 2021, 08:34:58 AM »
Did you get my Message? Sent you a link to what I believe Rick was recommending. Are there any numbers printed on the back of the broken sealed beam unit?
https://www.sylvania-automotive.com/sylvania-h4656-basic-sealed-beam-headlight-1-pack/H4656.BX.html

You should really post this in "General Discussion", not "Bike Builds, Rebuilds And Restorations Only".
Logged
Charlie

Offline Dluke

  • New Egg
  • *
  • *
  • Posts: 4
  • Location: Bend, Oregon USA
Re: CX100 Restoration
« Reply #2 on: August 16, 2021, 11:49:52 AM »
Yes I did Charlie, thank you!
Logged
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here