« previous next »
Pages: [1]   Go Down

Author Topic: EV wheel questions  (Read 1762 times)

wallooner

  • Guest
EV wheel questions
« on: August 08, 2015, 07:05:19 AM »
I have a 2004 EV. Touring.  It has the tubeless rims that were chromed.    The chrome is flaking and loos terrible.  My thought was to pull the wheels,  disassemble them,  have the rims sandblasted and powder coated silver.  Can anyone way in on this idea.  I need some good advise.
Logged

Offline johnr

  • Gaggle Hero
  • *****
  • Posts: 4343
  • Location: Invercargill NZ
Re: EV wheel questions
« Reply #1 on: August 08, 2015, 09:28:01 AM »
If you are going to strip them anyway why not get them re-chromed. But this time get the electroplater to put on a layer of copper then nickel first. No more rust if done well.

(Don't forget to make careful note of the spoke pattern before dis-assembly)
« Last Edit: August 08, 2015, 09:29:10 AM by johnr »
Logged
New Zealand
2002 Ev tourer (Stalled again...)

Offline Wayne Orwig

  • Gaggle Hero
  • *****
  • *
  • Posts: 14015
    • Hog Mountain weather
  • Location: Hog Mountain
Re: EV wheel questions
« Reply #2 on: August 08, 2015, 10:23:03 AM »
Not sure how sand blasting hard chrome on soft aluminum will work out.
Logged
Scientist have discovered that people will believe anything, if you first say "Scientists have discovered...."
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 


NEW WILDGUZZI PRODUCT - Moto Guzzi Door Mat
Receive donation credit with door mat purchase!
Advertise Here