Author Topic: 1983 Cal 2 float needle and seat  (Read 672 times)

Offline Pfribley

  • New Egg
  • *
  • Posts: 5
1983 Cal 2 float needle and seat
« on: September 15, 2019, 12:42:44 PM »
The float needle in my Cal 2 finally quit shutting off the fuel. A dismantling showed that the original needle had a ring around  it like one of saturns. Quick research revealed that the original needle was no longer available. Now I have to get completely new needle and seats. So a new pair of 250 needle arrived. The next question is " do I have to reset the float levels after replacing the old needle and seat with the new ones????" Thanks.

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 14707
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: 1983 Cal 2 float needle and seat
« Reply #1 on: September 15, 2019, 07:10:27 PM »
Yes, you should check the float level and adjust it if necessary.
Charlie

 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here