« previous next »
Pages: [1]   Go Down

Author Topic: Brake Master Cylinder Bolts  (Read 578 times)

Online Tom

  • Gaggle Hero
  • *****
  • *
  • Posts: 28791
Brake Master Cylinder Bolts
« on: October 27, 2020, 05:24:55 PM »
This is on a '93 Strada.  Should be similar to the other Tonti's with rectangular front master cylinder.  For front and back master cylinders.  Are the bolts 10mm x 1.25?  These would be the bolts that attach the brake lines to the master cylinders.  I know they're 10mm but wondering about the pitch.  I'm at the office and can't access the bike right now.  When I get home, I'll measure them and the bore where the bolt goes in.  Thanks.
Logged
From the Deep Deep South out in left field.  There are no stupid questions.  There are however stupid people asking questions.  🤣, this includes me.  😉 Hawaii.

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 14806
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: Brake Master Cylinder Bolts
« Reply #1 on: October 27, 2020, 07:03:35 PM »
Should be M10-1.0
Logged
Charlie

Online Tom

  • Gaggle Hero
  • *****
  • *
  • Posts: 28791
Re: Brake Master Cylinder Bolts
« Reply #2 on: October 27, 2020, 07:06:18 PM »
Looks like a re-examine of what I have and an outing to ACE for knickknacks.  Thanks.
Logged
From the Deep Deep South out in left field.  There are no stupid questions.  There are however stupid people asking questions.  🤣, this includes me.  😉 Hawaii.
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here