v9 Roamer bar risers?

[bad Chad]

I want to raise the bars.   I bought a set of bilt 22mm risers that seem pretty nice, however the bolt center on the risers are 32-36mm,  and they don't fit.  As I measure, Guzzi chose to use a 40mm distance center to center!  Anyone know where I can find risers with a 40mm bolt pattern?

[Joliet Jim]

I don't know whether this would work on the v9 or not, but do you remember when people were putting chrome socket underneath there with a longer bolt into the top trouble clamp? Would that possibly work on the v9?

ZZ

Craftsman forget the size but I've got two of them from the Stone

[greer]

Shaft collars work well, too.  A couple of them stacked together will get you right at an inch.

Sarah

[Dimitri_Harkov]

LSL has bar risers for the V9:
https://www.lsl.eu/121-m021?___store=en

But I guess shaft collars will do the trick for less $$$.

Cheers,
D.

[bad Chad]

Thanks, but those are bobber clamps, a little different.

Shaft collars?   Is that like a cock ring?   Just kidding, but really, what are shaft collars?

[Dimitri_Harkov]

Those fit both the Roamer & Bobber.

[Joliet Jim]

Thanks, but those are bobber clamps, a little different.

Shaft collars?   Is that like a cock ring?   Just kidding, but really, what are shaft collars?

when you were little they dropped you on your head a few times didn't they?

[bad Chad]

All resolved.  Thanks for the good ideas.   Used a rat tail file to increase to bolt pattern, worked like a charm.