« previous next »
Pages: 1 [2]   Go Down

Author Topic: Alternator Mount- Brush holder  (Read 4750 times)

Offline Frenchfrog

  • Gaggle Hero
  • *****
  • Posts: 936
Re: Alternator Mount- Brush holder
« Reply #30 on: June 11, 2022, 06:48:12 AM »
So wher are you at now? Curious minds must know !! :boozing:
Logged

Offline Jens_L

  • Hatchling
  • **
  • Posts: 26
  • Location: Belgium
Re: Alternator Mount- Brush holder
« Reply #31 on: June 15, 2022, 02:09:37 AM »

Quote from: Frenchfrog on June 11, 2022, 06:48:12 AM
So wher are you at now? Curious minds must know !! :boozing:




I had some spacers turned .1mm in between, outside diameter 14.8mm, inside diameter 8.5mm.
In this way I can adjust the spacing between the Silent Hektik rotor and the hall sensor if necessary.

As long as the brushes are in full contact with the alternator collector, I think there should be no problems.

Will make a picture when mounted!
Logged

Offline Frenchfrog

  • Gaggle Hero
  • *****
  • Posts: 936
Re: Alternator Mount- Brush holder
« Reply #32 on: June 15, 2022, 03:39:02 AM »
Good man ! You might need to adjust the alternator cover too.With the sachse you certainly have to ;either by putting washers behind it, getting one of their deeper covers or cover spacers.
Logged
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: 1 [2]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here