T3 Big Block Casting mount?

[wirespokes]

I don't know what to call it, but on the big blocks near the distributor, there's what looks like a place to mount something. Maybe a carry-over from the Loops? Would any of you know what it's for?

[Antietam Classic Cycle]

Below the distributor, aft of the right cylinder? It looks to me like Guzzi was thinking about a different location for the crankcase breather pipe - it's the same basic shape as the one inside the bellhousing.

Or on top of the 'case - ribbing with bolt holes? That would be where the generator bracket mounted on the "Loopframe" Guzzis.

[GuzziNZ]

My motors out at the moment and I was thinking another breather location as well.

[wirespokes]

Yeah - the one just aft of the right cylinder. Funny that they left it in the casting if it wasn't going to be used.

[moto]

It's funny. They did the same thing with ventilating duct work cast into the Griso dashboard housing; abandoned but still there. Making their designs up on the fly, but not throwing good money after bad.

[Antietam Classic Cycle]

Guzzi reused the mold for the Convert timing cover, revising it with upper engine mounts, for the Spine-frames. Didn't bother to remove the areas for the pump or fittings. As my mom often says "waste not, want not".