V700 and V750 cylinder options and recent costs

[benebob]

After a long hiatus to get the bad taste of owning a V7ii special clear up(yeah it really did take 3 years or so and a sea of mouthwash to move on).  I picked up a 67 V700  major project bike in the spring but then it poured and I picked up two project Triumphs which I went thru first.  This V700 is pretty rough.  Last inspected in 76 and as i add up the incidentals I think it may be more of a parts bike then a restoration project so I have been keeping my eye out for ideally another v700 project or an early v750 as I do prefer the look of the speedo only dash.  Anyways as I figure things out I wanted to get a more clear idea of what my options would be and what kind of costs I would be looking at as far as the cylinders goes.  From all the searching I've done it appears Gilardoni is done and all the stock has sold out for the V700 and V750.  I'm assuming that leaves sleeving at a place like LA Sleeve or Nik. lining as the only option or is there someone else making cylinders? Has anyone done sleeving or nik. recently and can give an idea on current costs for either or both? It also seems that new pistons for the 700 and 750 are fairly tough to come by and the ones I have seen are pretty pricey (though that may be just because I'm used to Redditich Enfield bits being cheaper then chips).  Still haven't pulled the head on the v700 but may get to it tomorrow to have a look at what exactly I have to work with and I did find a later 750 with the dual gauge dash that still has its chrome linings but it also has floorboards so I'm not so sure on going for a look as it is a distance and I prefer pegs.  Cheers

[Antietam Classic Cycle]

Yes, sleeving or "Nikasil" replating are the only options. I did two V700s ( a customer's and my own) using these new-old-stock piston assemblies: https://www.ebay.com/itm/365775501003 and had the cylinders replated by Millennium: https://millennium-technologies.com/all-inclusive-cylinder-repair/

Your original pistons may be reusable, measure them carefully and compare to the specs. in the factory manual.
https://www.thisoldtractor.com/mg_manuals/workshop_manual_700.pdf New rings are available:
https://www.ebay.com/itm/175671336189

[benebob]

Thanks Charlie, do they bill guzzis as standard twins (or two singles) or do they bill 'em as  a  combo v twin?  Very big price difference.  Have never had barrels coated.  I do plan on ridding the bike a fair amount of miles a year so would prefer to start fresh on heat cycles. 

[Antietam Classic Cycle]

Thanks Charlie, do they bill guzzis as standard twins (or two singles) or do they bill 'em as  a  combo v twin?  Very big price difference.  Have never had barrels coated.  I do plan on ridding the bike a fair amount of miles a year so would prefer to start fresh on heat cycles.

IIRC, they bill Guzzis as two singles, but it's been about five years since I sent them cylinders to replate, so I could be mistaken. Might be best to ask them.