Visit the Wildguzzi Amazon Affiliate Store
Looks lovely. Looks like it can also allow moisture in. Would a big o-ring or gasket be wise for that setup?Also—I want a mini mill. Right up my DIY alley and apartment-dwelling real estate allowance.
No locking fuel cap; you guys don't leave bikes parked overnight in shady places? Siphoned fuel or sugar in the tank (just for kicks).
If someone empties my tank on one of my motorcycles I lose a maximum of 20 bucks. If a key breaks one time I lose a lot more money. I remove locking gas caps on everything I own.
This is a nicely executed key eliminator, but my issue with a cap on my Guzzi is that it isn't hinged so I need somewhere, preferably clean, to set the fuel cap while filling the tank.
.. forget to put my gas cap back on my tank just ONCE..
Seriously? Maybe mid-20th century but I'd call that an urban legend now. I doubt anyone under the age of 50 even knows how to siphon gas. And to get maybe a gallon or two? I've never even thought to worry about this. -AJ
Sheltered lives. (Have you had a 'bike nicked, or your (same) house robbed three times? Rhetorical.)
Yours is very close to the one GTM made. I have the GTM one on my desk and will post a picture of it here tomorrow.
Updated with o-ring.I have enough rod and o-rings to make quite a few more if anyone is interested.
Nice of you to offer your talented handicraft for this. What might the cost be for those interested?
What year bikes would it fit? All lift off caps like the earlier Cali's?
Yes. My problem with it is twofold... it wasn't available (out of stock) and it looks like this after a few years of use.
Updated again.On the original key barrel there is a protrusion which limits the key turn to 90˚. None of the other replacements (Harper, GT) have that protrusion so I thought I didn't need it. Well, I found I could turn the knob 180˚ and over-tighten the cap, which makes it very difficult to remove. Just don't use as much force and stop at 90˚; easy enough right? Nope... I added the protrusion...