Visit the Wildguzzi Amazon Affiliate Store
Showa cartridges from a newer Honda are supposed to be the way to go. The tops need some machining to fit the Guzzi forks, but that's it. There's someone here that's done it, but don't recall who that is.
Thanks, will reach out to both you and steve for advice. Do you have to source special springs to make it work?
I read on this forum about someone (Huub?) fitting Showa cartridges to oem LM2 forks. I decided to upgrade my LM2 forks in the same way. The donor parts came from a set of VFR750 forks. My forks now have adjustable pre load and decent damping, fine tuned via oil viscocity and air gap.
I decided to "go down this rabbit hole" with my CX1100 project. Bought a cheap pair of VFR750 forks on ebay today. What viscosity oil are you using and what air gap?