Visit the Wildguzzi Amazon Affiliate Store
Showa cartridges from a newer Honda are supposed to be the way to go. The tops need some machining to fit the Guzzi forks, but that's it. There's someone here that's done it, but don't recall who that is.
Thanks, will reach out to both you and steve for advice. Do you have to source special springs to make it work?
I read on this forum about someone (Huub?) fitting Showa cartridges to oem LM2 forks. I decided to upgrade my LM2 forks in the same way. The donor parts came from a set of VFR750 forks. My forks now have adjustable pre load and decent damping, fine tuned via oil viscocity and air gap.
I decided to "go down this rabbit hole" with my CX1100 project. Bought a cheap pair of VFR750 forks on ebay today. What viscosity oil are you using and what air gap?
The LM2 has 2 springs fitted to each oem damper assembly as standard. One is longer than the other. After I'd got the Showa damper piston rod to the correct length I found the length of the longer oem spring was just about right to fit with the Showa, although I ended up fitting a 1" delrin spacer to the spring to slightly pre load it. Also the longer spring was measured at about 1kg/mm spring rate and I've found this to be fine on the road. I use Silkolene RSF 5w fork oil with 130mm air gap which is good for my bike as I've replaced the LM2 standard heavy as hell fairing set up with a pattern AirTech upper fairing.