Author Topic: clutch slave cylinder (Read 2722 times)

dxhall · « **on:** March 11, 2015, 09:09:55 PM »

I had to remove the clutch slave cylinder on my 2003 Sport Naked to replace the hydraulic line. As I was taking it off the transmission case, something fell out. Under the lift I found a single ball bearing which could, I suppose, fit into the cup in the clutch rod assembly. The parts book doesn't show it, though. Anyone know if there's a single ball bearing between the piston of the clutch slave and the rod assembly?

guzzisteve · « **Reply #1 on:** March 11, 2015, 09:46:15 PM »

Not unless someone put one there.

dxhall · « **Reply #2 on:** March 11, 2015, 10:47:49 PM »

Hmm. Where is there a loose ball bearing on this bike? I can't think of any...

twhitaker · « **Reply #3 on:** March 12, 2015, 06:13:58 AM »

About 5mm in diameter? Does the front brake light switch use one?

Vasco DG · « **Reply #4 on:** March 12, 2015, 06:19:16 AM »

Absolutely NFI!

5mm doesn't snag with anything I can think of either quickly or slowly?

Pete

Wildguzzi.com

News:

Author Topic: clutch slave cylinder (Read 2722 times)

dxhall

clutch slave cylinder

guzzisteve

Re: clutch slave cylinder

dxhall

Re: clutch slave cylinder

twhitaker

Re: clutch slave cylinder

Vasco DG

Re: clutch slave cylinder