Author Topic: clutch slave cylinder  (Read 4399 times)

Offline dxhall

  • Gaggle Hero
  • *****
  • *
  • Posts: 1267
clutch slave cylinder
« on: March 11, 2015, 09:09:55 PM »
I had to remove the clutch slave cylinder on my 2003 Sport Naked to replace the hydraulic line.  As I was taking it off the transmission case, something fell out.  Under the lift I found a single ball bearing which could, I suppose, fit into the cup in the clutch rod assembly.  The parts book doesn't show it, though.  Anyone know if there's a single ball bearing between the piston of the clutch slave and the rod assembly?

Offline guzzisteve

  • Gaggle Hero
  • *****
  • Posts: 13017
  • "Just Ride It"
Re: clutch slave cylinder
« Reply #1 on: March 11, 2015, 09:46:15 PM »
Not unless someone put one there.
"Pray through Carlo & your bike shall be healed"
Location: Planet Earth

Offline dxhall

  • Gaggle Hero
  • *****
  • *
  • Posts: 1267
Re: clutch slave cylinder
« Reply #2 on: March 11, 2015, 10:47:49 PM »
Hmm.  Where is there a loose ball bearing on this bike?  I can't think of any...

Offline twhitaker

  • Gaggle Hero
  • *****
  • Posts: 8323
Re: clutch slave cylinder
« Reply #3 on: March 12, 2015, 06:13:58 AM »
About 5mm in diameter? Does the front brake light switch use one?
'96 California 1100i 160,000 mi
'97 Centauro yellow 25,000 mi
'02 Champagne V11 LeMans 58,000 mi
MGNOC-11168
Dayton, OH

Vasco DG

  • Guest
Re: clutch slave cylinder
« Reply #4 on: March 12, 2015, 06:19:16 AM »
Absolutely NFI!

5mm doesn't snag with anything I can think of either quickly or slowly?

Pete

 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here