Author Topic: VHB questions  (Read 3480 times)

Offline Perazzimx14

  • Gaggle Hero
  • *****
  • Posts: 6492
VHB questions
« on: April 08, 2015, 10:22:49 AM »
Does anybody know the o-ring size for the choke jet? Also are there any alternatives for the accel. pump spring? The carbs off my next project cleaned up really nicely but were missing a few parts.

Thanks

Offline Idontwantapickle

  • Gaggle Hero
  • *****
  • *
  • Posts: 1683
  • The rotation of the earth really makes my day.
  • Location: Closer than farther away
Re: VHB questions
« Reply #1 on: April 08, 2015, 10:30:19 AM »
O ring is 2.5mm ID 5.5mm OD. Spring and gaskets sets for VHB are available from MG Cycle as well as some others.
Hunter
There is no end to what we can do together.
Sir James Paul McCartney

AMA Charter Life Member

72 Eldo
85 LeMans 1000 Loud, Fast and Red
2007 Norge rivestimento di argento
84 BMW R100RS

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 15183
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: VHB questions
« Reply #2 on: April 08, 2015, 10:51:54 AM »
Does anybody know the o-ring size for the choke jet? Also are there any alternatives for the accel. pump spring? The carbs off my next project cleaned up really nicely but were missing a few parts.

Thanks

http://www.thisoldtractor.com/moto_guzzi_loopframe__for_sealing_the_carburetor_enricher_jet_to_the_float_bowl_-13936100-.html

I have some in stock and also the accelerator pump spring too. Anything else you're missing?
Charlie

 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here