part needed - rear turn signal wire boot

[nc43bsa]

My non-OEM rear turn signals have 12mm threaded stalks with 17mm nuts.  What I'm looking for is a rubber right-angle boot that would snap onto the nut and stalk and accept the tube that encloses the signal wires.

Since the signals are non-OEM, the boots don't need to be Guzzi either.

The signals are mounted on H-B mounts and the wires are out hanging in the breeze.  They don't need to be waterproof, I just want to conceal them somewhat.

Any part number suggestions?

[rodekyll]

Get a few inches of shrink tube and roll your own.

[Antietam Classic Cycle]

http://www.mgcycle.com/index.php?main_page=product_info&cPath=37&products_id=319

[nc43bsa]

I believe I'll add that to my next order.  They're certainly cheap enough.  <snap suspenders>