« previous next »
Pages: [1]   Go Down

Author Topic: Steering stems/ bearings/ axle sizes?  (Read 1494 times)

Offline Toecutter

  • Gaggle Hero
  • *****
  • Posts: 1042
Steering stems/ bearings/ axle sizes?
« on: September 28, 2016, 09:21:44 AM »
Can anyone tell me if any (and which) models share steering bearing & stem sizes? Hell... axles, too, if anyone knows.

Logged
Old enough to say I've done it, young enough to do it again.

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • Posts: 15070
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: Steering stems/ bearings/ axle sizes?
« Reply #1 on: September 28, 2016, 09:31:55 AM »
All of the Loopframe and Tonti frame "big twins" from the V700 to the Cal Vin have the same steering head bearing, industry number 30205. There are three different steering head heights though.

Logged
Charlie

Offline guzzisteve

  • Gaggle Hero
  • *****
  • Posts: 12886
  • "Just Ride It"
Re: Steering stems/ bearings/ axle sizes?
« Reply #2 on: September 28, 2016, 09:55:40 AM »
Early Spines also for steering, V11Sports I have not done but most likely the same.
Logged
"Pray through Carlo & your bike shall be healed"
Location: Planet Earth

Offline malik

  • Gaggle Hero
  • *****
  • Posts: 2420
  • Location: Sydney, Australia
Re: Steering stems/ bearings/ axle sizes?
« Reply #3 on: September 28, 2016, 04:23:37 PM »
I found them listed on "this old tractor". Very useful.
Logged
2010 V7 Classic, 2014 V7 Special
1996 1100 Sport Carb (in NZ), 2004 V11 LeMans (in UK)
Carberry Enfield V-Twin, 2008 Royal Enfield Electra, 2006 RE Electra 535
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here