New Moto Guzzi Door Mats Available Now
I get to respond to this, since I own one ( 2007 RWB anniversary edition) Like any motorcycle, my 800 VFR has its good and bad points. First the Bad: Torque...there isn't any. Like most Japanese multi-cylinder engines, you have to spin it to make power. With a 12,000 RPM red line, the thing doesn't get out of it's own way until about 8 grand. Fine at a track day, but not so much on the street. The stupid 2 valve/4 valve VTEC...really? Someone at Honda thought it was a good idea to put a step right in the middle of the power band? I thought that went away with the two-strokes. It's a pointless gimmick that adds nothing to the bike. Everyone who's ever ridden the older geared cam versions (without VTEC) say they are much better. The Good: Light weight (by most standards), smooth running, and the bike has wonderful neutral handling...probably it's best feature. A nice large fuel tank for 200+ mile range. I'm partial to single sided swing arms. They make rear wheel changes a 10 minute affair, of course a CARC Moto Guzzi rider already knows that. I have the factory hard bags on mine so it's sort of a gentleman's sport touring bike. I can ride it all day, and there aren't many sport bikes I can say that about. Plus I like the look of mine and get more than a few complements on it (I'm shallow, I know!)Plus, being a Honda, I just change the oil and throw on a fresh set of tires every so often. They are out there for cheap money. Ride one and see if you like it.
When I'm cooking on the VFR I rarely go below 6,000. I can't imagine riding my CX like that except for short periods.
What Wayne doesn't know is that it has been completely restored to like new condition!
With all multi (four) cylinder machines you have to keep your revs up for power. If your used to short shifting a twin it would seem that there is a lack or torque but.....no torque? not so.VFR 750 F....53.7 ftlb@ 8000 rpm.850 Breva....51.6 ftlb@ 7000 rpm.8000 rpm is barley breathing on the Honda, but 7000 rpm on the Breva is at or near the line.Need to learn how to use the wonderful flat torque curve of the V 4.When I'm cooking on the VFR I rarely go below 6,000. I can't imagine riding my CX like that except for short periods.:-)
50ft/lbs from an 800cc four cylinder sport tourer is kind of pathetic. Especially when you have to rev the tits off the thing to get it. Riding one with a passenger immediately brings that flaw to the forefront. VTEC exacerbates the problem. They weigh as much as a Norge or 1200 Sport, have similar ergonomics but 20ft/lbs less torque. However, I�d buy an Anniversary edition in a heartbeat if I stumbled onto a deal because they�re great looking and VFR�s age incredibly well. They have higher build quality than 90% of the bikes on the market and that shows decades later.
Glad to hear that. It has been a few years since I saw it. What caused all the bodywork to need replacing?
8000 rpm on a VFR is hardly revving the tits off it....and 50 ftlb of torque for an 850 twin is revving the tits off it. Not only that the V4 is putting more HP to the ground at 8000rpm than the twin at 7000.Ridden 1000's of miles two up on the 750 VFR loaded...easy.
Best bike produced by humans. Ever. By a large margin. i love mine and the bike has never been the limiting factor. And you can hoon like below, and that is fun.