1976 850 T

[commander]

Hello were is a good place to get transmission parts here in the states.
Need a bearing, thanks

[lucian]

Try Harpers MG or MG cycles 

http://www.harpermoto.com/

http://www.mgcycle.com/

[guzzisteve]

Top 3--  MG Cycle, Moto International, Harpers. For bearings I go to Bearing Supply.

[blackcat]

Top 3--  MG Cycle, Moto International, Harpers. For bearings I go to Bearing Supply.

Yeah, I just get a bearing from the local supplier.

[Antietam Classic Cycle]

Which bearing do you need commander? Five speed transmissions have bearings that can be difficult to find. Some are not readily available from a local bearing supplier.

http://thisoldtractor.com/moto_guzzi_loopframe_transmission_bearing_cross-references_-_5_speeds.html

[commander]

Thanks guys, hate to say it but harpers is giving me the run around.
I will get a number and get back to you.

[troyhamilton]

Mike Harper and Curtis Harper are on this discussion board and have been very helpfull to me.

[n3303j]

 https://www.123bearing.com
These guys are far awway in France.
They had every bearing and seal used in the EV final drive.


The bearings were SKF Explorer series (as I requested) except for the oddball needle which they matched to OEM brand.
Seals were Viton (as I requested).
Pricing (with shipping) was about half of any other supplier I tried.
They have a USA phone number that is manned by friendly and helpful people who know their product and are efficient communicators.
Purchase was seamless with a Visa card.
Delivery was 5 days from my phone call!!

No Surprises, just a well run business!
They have become my first stop for bearings (unless the need is immediate).

[motormike131]

   I needed crankcase bearings and seals for a 2 stroke 1952 French m/c. Took a sample of both down to the local bearing dudes... Ten minutes.. $30.oo later.. out the door a happy camper. :)

[Antietam Classic Cycle]

https://www.123bearing.com
These guys are far awway in France.
They had every bearing and seal used in the EV final drive.


The bearings were SKF Explorer series (as I requested) except for the oddball needle which they matched to OEM brand.
Seals were Viton (as I requested).
Pricing (with shipping) was about half of any other supplier I tried.
They have a USA phone number that is manned by friendly and helpful people who know their product and are efficient communicators.
Purchase was seamless with a Visa card.
Delivery was 5 days from my phone call!!

No Surprises, just a well run business!
They have become my first stop for bearings (unless the need is immediate).

I've bought from them twice now also. All of the bearings for a 4 spd. transmission are ~ $100 shipped. However, the bearings for a 5 spd. are much less "common" and so cost considerably more. I put all 6 of the bearings needed for a 5 spd. in my cart and the total before shipping is $355.