Visit the Wildguzzi Amazon Affiliate Store
Consummate craftsmanship. Beautiful.Rich
Lucian, what I like to do as prep is take it down to the metal, using aircraft paint remover, and or an abrasive disc, especially where the fenders are chromed, to get good paint adhesion. I finish this with 320 grit sandpaper, so the primer sealer will get a good"bite". I then spray Nason epoxy primer sealer on everything, then block sand with 400 then 600 grit to get the surface smooth and flat. Now I spray the basecoat color, and if I have to tape for a second color, I will spray a light coat of clear to allow me as much time as I need for taping, etc. ( you have a couple of hours "window"to spray the clear over the base, so it bonds to the base, and wont peel, but once you have some clear down ,you can always go back and scuff it with 600 grit, and continue adding layers of clear as needed) I like to wet sand the clear with 600 grit , adding coats of clear until you cant feel any of the paint lines, and then I finish it by buffing with a foam pad on the drill using a 3M swirl mark remover , which is a very fine compound. How many times you wet sand and re clear is the trick to getting a deep, glass like finish.Rick.