« previous next »
Pages: [1]   Go Down

Author Topic: Eldo fork question  (Read 924 times)

Offline izzuG

  • Hatchling
  • **
  • *
  • Posts: 67
  • Location: Western Mass
Eldo fork question
« on: June 30, 2021, 08:31:40 AM »
Pulled the speedo cover off my 1974 Eldo so i could replace the fork fluid, i noticed the top plugs have a threaded hole on top....should there be something in there? Sorry in advance if this is a new

by question🙂
Logged

Offline Don G

  • Gaggle Hero
  • *****
  • Posts: 1065
  • Location: Smiley, Saskatchewan Canada
Re: Eldo fork question
« Reply #1 on: June 30, 2021, 08:41:41 AM »
 :grin:Yeah, the screw that holds the cover on!  DonG
« Last Edit: June 30, 2021, 08:45:15 AM by Don G »
Logged

Offline izzuG

  • Hatchling
  • **
  • *
  • Posts: 67
  • Location: Western Mass
Re: Eldo fork question
« Reply #2 on: June 30, 2021, 08:51:55 AM »
Dag nabbit, at least I was smart enough to know it was a dumb question! Thanks
Logged

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 15180
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: Eldo fork question
« Reply #3 on: June 30, 2021, 03:15:12 PM »
On civilian Eldos, rubber isolators thread into those holes to mount the (dual gauge) instrument cluster.
Logged
Charlie
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here