V9 crank sensor gap

[tris]

When it arrives I need to fit a new crank sensor to my 17 plate Roamer so am doing a bit of prep in the interim.

Key wuestion is what is the air gap as I can't find anything in the manuals

Interestingly the parts fiche don't show any shims

I wonder if the modern machine tools put the mounting face where it should be without the need for any shims

Any ideas anyone??

Cheers

[guzzisteve]

If you haven't pulled it out, it may have a sliver of metal on it. Could be the issue.

[Chuck in Indiana]

I *assume* its the same as everything else.. .6 to1.2mm. so not very fussy.

[guzzisteve]

this is what it says in V7-2 ABS----------------------------
"Place the sensor plus the corresponding spacers; the air gap should be between 0.7 and 0.9 mm."
V9 motor man just says check correct air gap, doesn't list what it is anywhere I looked, in V9 Roamer & Bobber.
The place it was listed was in the sensors trouble shooting section.

If the part # is same for V7 & 9, tone wheel & sensor then air gap would be same also.