carbtune nipples missing

[DAM650]

good morning

anyone know what and where I should buy for a 2013 NTX?

got the carbtune with the bike, but it's missing the little nipples

thx in advance


DAM

[guzzisteve]

It there a line running from L to R intake manifolds? That is where you attach hoses.


They also make this in 5mm--------------------------------------------

https://www.denniskirk.com/tecmate/carbmate-brass-m6-threaded-adapter-ts-204.p283050.prd/283050.sku

[Bulldog9]

good morning

anyone know what and where I should buy for a 2013 NTX?

got the carbtune with the bike, but it's missing the little nipples

thx in advance


DAM

I just pull the vacuum lines for the evap system off the nipples.

[John A]

Tips from a mig welder can be used. Get the ones with the appropriate metric threads and they screw right in.

[DAM650]

thanks all, i got some off of amazonica. 

time to replace the exhaust gasket, grease the swingarm bearings and dogbone needles, and of course do another quick valve check (they were spot on), then balance the TBs.

ran a 2K trip last week up to Mountain Grove MO, crafted a twisty .gpx file using AI, what a time saver.

bike ran like a top, avg about 37 mpg fully loaded, rattled my laminar lip and running light loose running down some dirt roads and blew out her o ring about 100 miles from home.  was sh!tting my pants thinking that i was loosing the top end until i stopped and found the exhaust leak.

what a mile eater.

DAM 

[Kiwi_Roy]

Buy a pack of 6mm grease zerts.
Take a file to the threaded end until the spring pops out then push the ball out as well.
Now you have a nipple for carb balancing.