Moto guzzi v9 Ecu bricked?

[Bertil]

I saved the .bin from my guzzi v9 2016, then i switched off the lambda’s with tunerpro and tried to write it back.
The original bin file got erased and the upload started but at almost the end the starterengine suddenly started turning so i turned of the Ignition switch. Realising something went wrong i tried to write the original bin file back but No connection is possible because everytime i switch the ignition to ON the starterengine gets activated. What can i do?

[n3303j]

Disconnect the starter?

[Bertil]

Done that but now can’t get connected.

[Tom H]

I found this some time ago. I don't think it's you ECU model, but it might help if your is bricked:

From Ed AF1
"one trick I know of on the Aprilia 7SM and using GD is to go into the GD writer,

go in and start to write a new map to the bricked ECU...pick any map, doesnt matter

The trick is to ignore the key on, off instructions.  Have the key off, until after you start the writing process (after clicking all the oks to start it).   Then turn on the key, and that seems to connect to the ECU in boot mode right when it gets power, and starts a fresh delete and re-loading of the map.  A fresh full reload is all it needs to be fixed."

Tom

[Bertil]

Hi Tom,
I have tried this. First write, ignition on then OK, second time, write, OK, ignition on. And a third time, ignition on, write OK.
The writer says ignition is off. So no connection.

[Tom H]

You might try checking your fuses, unlikely, but maybe? Is the kill switch set to run? Been there.

Tom

[Bertil]

Fuses OK, kill switch OK.

[Bulldog9]

Reach out to Beetle. If anyone will know he will.

[Ncdan]

^^^^
+1 with contacting “guzzi or death” (beetle)

[Bertil]

Hoe do i contact Beetle?