Connecting rods

[gph70]

It would be great if my reasoning could be verified.

I am reassembling the connecting rods on the crank with new big end bearings and having read everything in the manuals, searched the forum and looked at G Bender's site, I have concluded the following: As these rods do not have oil holes on the sides, "B" in the manuals, the rods can go in any direction, i.e. there is no up or down.
I realize it is a basic question but with verification, the mind rests and progress resumes.



thanks in advance

[Tom H]

If they do not have the oiling holes on the side, then they should be able to go either direction. IF, they have Guzzi or Motoguzzi cast on them, then I would face the logo to the front of the engine.

Hope this helps,
Tom

[gph70]

it does, and thanks