« previous next »
Pages: [1]   Go Down

Author Topic: V50 III brKe disc wear limits  (Read 2236 times)

Offline chrisk

  • Gosling
  • ***
  • Posts: 144
V50 III brKe disc wear limits
« on: August 19, 2015, 01:36:08 PM »
I've just seen the prices of replacement disks so am now thinking I may get mine ground as they are quite pitted.

The Manual says "the thickness of the front and rear disk (new disk) 5.85 to 6.0" but it says nothing about old discs. Do I read this to be 5.85 is the lower limit?
Logged

Vasco DG

  • Guest
Re: V50 III brKe disc wear limits
« Reply #1 on: August 19, 2015, 01:52:15 PM »
Minimum thickness should be cast into the disc/carrier somewhere.

Pete
Logged

Offline chrisk

  • Gosling
  • ***
  • Posts: 144
Re: V50 III brKe disc wear limits
« Reply #2 on: August 21, 2015, 02:36:18 AM »
Had a good look, can't see any writing anywhere...
Logged

Offline Chuck in Indiana

  • Gaggle Hero
  • *****
  • *
  • Posts: 29707
Re: V50 III brKe disc wear limits
« Reply #3 on: August 21, 2015, 07:26:34 AM »
I couldn't find wear limits in the shop manuals I looked at.
From EBC
Quote
Motorcycle discs have much lower wear tolerances, generally half of one mm each side means the rotor is worn out and should be replaced.
Logged
Chuck in (Elwood) Indiana/sometimes SoCal
 
87 AeroLario
95 Skorpion tour
26 Triumph trident 800
"Social media made y'all way too comfortable with disrespecting people and not getting punched in the face for it."

Mike Tyson
*IMPROVED* - Wildguzzi Amazon Affiliate Storefront!
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

*IMPROVED* - Wildguzzi Amazon Affiliate Storefront!
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here