1999 Moto Guzzi clutch lever bushing

[bikeridertim]

Dose anybody have a part number for a 1999 Moto Guzzi EV11 clutch lever bushing? I only got 146,000 out of the original! 
OR can anybody explain the extra lip?? (makes it look like a tophat) I am sure I can make one, but I'm confused as to the lip??   
Thanks in advance!
Bikeridertim

[fotoguzzi]

not sure what bushing you are asking about, here's parts book for a 2002 big block probably the same,

http://www.thisoldtractor.com/mg_manuals/spare_parts_catalog_california_aluminum_special_sport.pdf

you might want to browse around here for other manuals,

http://www.thisoldtractor.com/moto_guzzi_tonti_spare_parts_catalogs___exploded_parts_diagrams___parts_fiche.html

[bikeridertim]

I'm looking for the hand lever bushing.........
None of the parts books show just the bushing.
.

[LowRyter]

http://www.harpermoto.com/parts-by-motorcycle/1990-2000-moto-guzzi-motorcycles/california-ev-v11-ev-usa-1100-1997-2000/handlebar-controls-en-california-1100-ev.html

[sib]

This may or not be helpful:  the black plastic bushing used in the later V7s doesn't seem to have its own part number and isn't even shown in the parts manuals.  However, I believe it is Domino/Tommaselli part 97.1662.  It is usually supplied with the clutch lever if you order part GU30605700 (you can also buy the lever alone as part GU32605511 or the whole lever assembly as part GU32605510).  Good luck.

[twhitaker]

I had Lee Bruns make me one out of bronze for about 10 bucks 15 years ago. I'll see if I can find the drawing at work tomorrow.

[Gootsz]

I just went to Ace hardware, got a nylon bushing. pressed it into the lever and drilled to fit. @2.00

Micky

[bikeridertim]

Thanks guys Im just going to make one