« previous next »
Pages: [1]   Go Down

Author Topic: Cluch Hub nut Torque setting ??  (Read 2873 times)

Offline Peter949

  • PeterCaliII
  • Gosling
  • ***
  • Posts: 189
  • 84 Cali II
  • Location: Creemore Ontario Canada
Cluch Hub nut Torque setting ??
« on: November 22, 2018, 10:17:09 AM »
I am about to 'Crab the Frame' and finally rebuild the sticky clutch on my old California II.

Can anyone tell me the Torque Setting for the large nut that secures the Clutch Hub?  I could not find this value anywhere.  :sad:  Any other 'tips' for this project would be greatly appreciated.



 
Logged
Peter

1984  Cali II
Aprilia 125 Sportcity Scooter

Offline Don G

  • Gaggle Hero
  • *****
  • Posts: 1065
  • Location: Smiley, Saskatchewan Canada
Re: Cluch Hub nut Torque setting ??
« Reply #1 on: November 22, 2018, 10:46:14 AM »
I usually just rattle them up tight with a 1/2" impact, put a little medium strength lock tight on the threads first.  DonG
Logged

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 15178
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: Cluch Hub nut Torque setting ??
« Reply #2 on: November 22, 2018, 10:53:00 AM »
The factory spec. is 115-129 ft. lbs.
Logged
Charlie
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here