« previous next »
Pages: [1]   Go Down

Author Topic: clutch slave cylinder  (Read 2720 times)

Offline dxhall

  • Gaggle Hero
  • *****
  • *
  • *
  • Posts: 1267
clutch slave cylinder
« on: March 11, 2015, 09:09:55 PM »
I had to remove the clutch slave cylinder on my 2003 Sport Naked to replace the hydraulic line.  As I was taking it off the transmission case, something fell out.  Under the lift I found a single ball bearing which could, I suppose, fit into the cup in the clutch rod assembly.  The parts book doesn't show it, though.  Anyone know if there's a single ball bearing between the piston of the clutch slave and the rod assembly?
Logged

Offline guzzisteve

  • Gaggle Hero
  • *****
  • Posts: 12247
  • "Just Ride It"
Re: clutch slave cylinder
« Reply #1 on: March 11, 2015, 09:46:15 PM »
Not unless someone put one there.
Logged
"Pray through Carlo & your bike shall be healed"
Location: Planet Earth

Offline dxhall

  • Gaggle Hero
  • *****
  • *
  • *
  • Posts: 1267
Re: clutch slave cylinder
« Reply #2 on: March 11, 2015, 10:47:49 PM »
Hmm.  Where is there a loose ball bearing on this bike?  I can't think of any...
Logged

Offline twhitaker

  • Gaggle Hero
  • *****
  • Posts: 8323
Re: clutch slave cylinder
« Reply #3 on: March 12, 2015, 06:13:58 AM »
About 5mm in diameter? Does the front brake light switch use one?
Logged
'96 California 1100i 160,000 mi
'97 Centauro yellow 25,000 mi
'02 Champagne V11 LeMans 58,000 mi
MGNOC-11168
Dayton, OH

Vasco DG

  • Guest
Re: clutch slave cylinder
« Reply #4 on: March 12, 2015, 06:19:16 AM »
Absolutely NFI!

5mm doesn't snag with anything I can think of either quickly or slowly?

Pete
Logged
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here