Help identifying “hydro” valve fix please!

[inditx]

Need your help.
I see the “shiny hats” but is this the best and final fix that I read about on the hydro?
It’s on a 2004 EV that I’m looking to buy.

Pics of single or dual clutch to follow.

Thanks in advance for your expeditious help.
inditx


what does screen resolution do

[Tom H]

Yes it has had a recall done. I "think" the only way to tell which one is the cam and the hydro lifters?

The only thing that bothers me in the pics is the brass shims. I need to look at my EVT, but I think there should only be one brass shim per rocker, it looks like you have 2 per rocker. The other thing is that "normally" the shim and spring would be set up with the shim against the rocker block and the spring against the rocker. I don't know if that makes any difference, but "most" bikes have the spring against the rocker.

Hope this helps a bit,
Tom

[inditx]

It does, I guess the thing I’m seeing is the broken off studs and shiny hats so it should be good to go?
inditx

[lucky phil]

Yes it has had a recall done. I "think" the only way to tell which one is the cam and the hydro lifters?

The only thing that bothers me in the pics is the brass shims. I need to look at my EVT, but I think there should only be one brass shim per rocker, it looks like you have 2 per rocker. The other thing is that "normally" the shim and spring would be set up with the shim against the rocker block and the spring against the rocker. I don't know if that makes any difference, but "most" bikes have the spring against the rocker.

Hope this helps a bit,
Tom

Nope 2 per rocker otherwise you have a cast steel rocker bearing against an alloy rocker support.

Phil

[inditx]

Nope 2 per rocker otherwise you have a cast steel rocker bearing against an alloy rocker support.

Phil

Thanks Phil!

[Antietam Classic Cycle]

IIRC, on square-fins there are two brass shims on either side of the rocker and a steel shim against the alloy rocker support, spring between the brass and steel. That's why I made an alignment drift - to get all the bits lined up so I could get the pin back in more easily.

[Tom H]

I didn't know that the square fins were set up this way. Thanks for the info!!

Tom

[inditx]

 

[egschade]

This is how my EV looked after the work was done. Snapped off valve adjuster is the indicator.

[inditx]