Author Topic: Loop header clamps  (Read 375 times)

Online wirespokes

  • Gaggle Hero
  • *****
  • Posts: 2449
Loop header clamps
« on: November 04, 2026, 07:41:52 PM »
Eldorados and Ambassadors have clamps on the headers to the frame. Just wondering how necessary they are since the newer bikes don't have them. Maybe the threaded-in header retainers aren't as robust and it makes a difference?

Offline Tom H

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 3806
  • Location: So. Cal.
Re: Loop header clamps
« Reply #1 on: November 05, 2026, 11:02:09 AM »
If your using the mufflers with the crossover, then the header to frame clamps are not needed, though if I had the clamps I would use them.

If your using mufflers without the crossover, then it's a must to run the clamps. The mufflers could wiggle a bit and cause the header to head nut to loosen.

JMHO,
Tom
2004 Cali EV Touring
1972 Eldo
1970 Ambo V1000
1973 R75/5 SWB with Toaster
1973 R75/5 LWB
2007 HD Street Bob
1953 Triumph 6T (one day it will be on the road!)

Offline Fontain25

  • Gosling
  • ***
  • Posts: 135
  • Location: Illinois USA
Re: Loop header clamps
« Reply #2 on: November 11, 2026, 04:47:10 PM »
The original aluminum clamps are hard to find. they make a steel clamp that would do the job.

Online wirespokes

  • Gaggle Hero
  • *****
  • Posts: 2449
Re: Loop header clamps
« Reply #3 on: November 11, 2026, 06:46:28 PM »
I just got some used steel ones. Is there anything to be done against scratching the frame or headers?


 

*IMPROVED* - Wildguzzi Amazon Affiliate Storefront!
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here