« previous next »
Pages: [1]   Go Down

Author Topic: Breva 1100 head/cylinder torque  (Read 3442 times)

Offline EvanM

  • Gaggle Mentor
  • ****
  • Posts: 444
Breva 1100 head/cylinder torque
« on: April 18, 2015, 01:37:10 PM »
I am putting back on my heads and cylinders today/tomorrow, and was wondering what I should be torquing them to, as that info was not in the service manual.
Anyone know the specs?

Thanks,
Evan
Logged
2007 Breva 1100

Vasco DG

  • Guest
Re: Breva 1100 head/cylinder torque
« Reply #1 on: April 18, 2015, 04:22:59 PM »
There are two torque values, one for the stud nuts and one for the bolts. You also tighten them first to a preluminary torque value which I'll have to look up and then use a RTG. It's +90+90 for the nuts and +90 for the bolts.

Pete
Logged

Offline EvanM

  • Gaggle Mentor
  • ****
  • Posts: 444
Re: Breva 1100 head/cylinder torque
« Reply #2 on: April 18, 2015, 04:28:33 PM »
Hey Pete,  what's RTG?

Thanks for the reply and looking up the torque
Logged
2007 Breva 1100

Vasco DG

  • Guest
Re: Breva 1100 head/cylinder torque
« Reply #3 on: April 18, 2015, 04:46:30 PM »
Radial torque guage.

Preliminary torque 11.06 ft/lbs or 15Nm for both nuts and bolts then two steps for the nuts and one for the bolts.

Pete
« Last Edit: April 18, 2015, 04:56:17 PM by Vasco DG »
Logged
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here