« previous next »
Pages: [1]   Go Down

Author Topic: Breva 1100 head/cylinder torque  (Read 2597 times)

Offline EvanM

  • Gosling
  • ***
  • Posts: 444
Breva 1100 head/cylinder torque
« on: April 18, 2015, 01:37:10 PM »
I am putting back on my heads and cylinders today/tomorrow, and was wondering what I should be torquing them to, as that info was not in the service manual.
Anyone know the specs?

Thanks,
Evan
Logged
2007 Breva 1100

Vasco DG

  • Guest
Re: Breva 1100 head/cylinder torque
« Reply #1 on: April 18, 2015, 04:22:59 PM »
There are two torque values, one for the stud nuts and one for the bolts. You also tighten them first to a preluminary torque value which I'll have to look up and then use a RTG. It's +90+90 for the nuts and +90 for the bolts.

Pete
Logged

Offline EvanM

  • Gosling
  • ***
  • Posts: 444
Re: Breva 1100 head/cylinder torque
« Reply #2 on: April 18, 2015, 04:28:33 PM »
Hey Pete,  what's RTG?

Thanks for the reply and looking up the torque
Logged
2007 Breva 1100

Vasco DG

  • Guest
Re: Breva 1100 head/cylinder torque
« Reply #3 on: April 18, 2015, 04:46:30 PM »
Radial torque guage.

Preliminary torque 11.06 ft/lbs or 15Nm for both nuts and bolts then two steps for the nuts and one for the bolts.

Pete
« Last Edit: April 18, 2015, 04:56:17 PM by Vasco DG »
Logged
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here