Need ID of EV/Jackal upper fork tubes

[rodekyll]

Title says it -- if someone has a bare upper tube for an EV/Jackal (late model Tont = 45mm outside?) lying about, could you measure the inside diameter for me?  Thank you kindly!

(edited for typo)

[John A]

FOTOGUZZI GO OUT AND MEASURE THE ID OF THAT SPARE SET OF TUBES.!,! I may want to buy them, let's talk

[John A]

Brad probly doesn't have the plugs out or the lower legs off. He told me he had a set off an EV, I may buy them for another project I have in mind.

[stEVe]

I've got a set for sale. They are attached to my 98 EV. New seals a while back. 86,000 miles or so on the bike. Cosmetically not the best but mechanically sound and you can drive it anywhere!. $2,000. It's listed on the classifieds on this site.

[fotoguzzi]

FOTOGUZZI GO OUT AND MEASURE THE ID OF THAT SPARE SET OF TUBES.!,! I may want to buy them, let's talk

I'll take apart tonight and get the measurement.

[Orange Guzzi]

I replaced my upper tubes with a set from a Bassa.  I now have compression and rebound dampening.  Direct replacement.  Along with seals and teflon coated bushngs.  Good luck finding  donor pair though.  I do have the oem Jackle set with after market compression dampers, YSS brand.

[rodekyll]

I'm trying to find out how close the ID of a jackal/EV tube is to the OD of various leading link forks that I know are too small a tube to fit my trees.  If they fit the forks, perhaps with heat and presswork, I could slide them up the tubes and weld them in place.