Re-setting the service wrench icon on the V85's

[Tom H]

With the 2 adapter cables included with the the device you were able to reset the service on your E5?

If so, this is different than the V7III not II's that I HAD to connect to the MGMP (??) cable that lives between the battery and rear fender.

Tom

[RJE_MD]

Hi Tom
I just checked which plug I used.  It is the MT04-1 and plugs into a connector that is located next to the ECU under the seat.  Bonus- the scanner was powered by this plug, so I didn't need to connect the leads to the battery.  I'll admit I'm pretty new to bikes with computers, so I'm not sure what the MGMP is or what it looks like. My others are pre-computer Yamahas and a very crusty older Vespa.

Good luck!

[Kev m]

With the 2 adapter cables included with the the device you were able to reset the service on your E5?

If so, this is different than the V7II's that I HAD to connect to the MGMP (??) cable that lives between the battery and rear fender.

Tom

Wait - V7II? Or did you mean V7III?

I thought the V7II still used the old dash like the V7C or the MkI V7 series like my Stone. On them you didn't need a tool for the reset.

[bad Chad]

All this, plus hundreds of dollars and maybe you can turn off your little orange light!😆😆

[guzzisteve]

You can rent a Duonix 2 here https://www.ebay.com/itm/136113516799 to reset your light for probably less than the cost of a dealor.

Place is in Stevens Point , WI   might be worth it if in IL

[buck]

With the 2 adapter cables included with the the device you were able to reset the service on your E5?

If so, this is different than the V7II's that I HAD to connect to the MGMP (??) cable that lives between the battery and rear fender.

Tom

I just looked and confirmed the Icarsoft unit comes with the MT-04 adaptor he used to reset the service light.

[Tom H]

Kev M, I meant the V7III not the II. Slight type.

So the red tip cable will do the E5's. Not sure if I have done an E5 yet. Thanks for the tip!!!!

Tom